Say What?!™ Wireless Chime This package includes (Style of push button and chime may vary from illustration): * Wireless chime + Wireless push button with demonstration batteries « Hardware pack + Door hanger + Audio cable (7 Jumper Model Only) You'll need to buy 3 "C" alkaline batteries for the chime. In typical use, alkaline batteries will last up to one year. 1. Install 4 type “AA" alkaline batteries. Open back of case by removing screw at top of hatchery caver with small philistine-head screwdriver.
6. Mount push button and chime. Use either screw, door hanger, or double sided tape to mount push button. To mount with screw, determine where push button will be located. Using 3/16" drill bit, drill tap hole. If screw is not mounted directly info wood stud or trim molding, use drywall anchor. Insert screw leaving approximately 1/8" gap between head of screw and wall. Place keyhole slot on rear of push button over the screw’s head and slide down firmly.
Chime Tune Settings Your wireless chime has different delectable tune modes: 4 prerecorded sounds and 1 setting that cycles through the 4 prerecorded sounds (the 7 jumper model adds the ability to record up to 10 seconds of audio via the audio cable or built-in microphone). To select different tune modes, slide switch located on right side of chime to numbers | through 4 (0 select the prerecorded sound desired. Select “All” to allow chime to cycle through the 4 prerecorded sounds each time the chime sounds.
Troubleshooting Chime doesn't sound: * Make sure push button and chime codes are the same (See pages 2 and 3). = Check orientation of push button and chime batteries (See markings inside push button and chime). + Check charge of push button and chime batteries, replace if necessary. « Verify push button and chime are within 50 feet of each other. Batteries seem OK, but the chime doesn't work when installed: + Don't mount chime or push button on metal or near metal studs. This reduces the transmitter range.
YOUR ONE YEAR LIMITED WARRANTY This is a "Limited Warranty" which gives you specific legal rights. You may also have other rights which vary from state to state or province to province. For a period of one year from the date of purchase, any malfunction caused by factory defective parts or workmanship will be corrected at no charge to you. Batteries are not covered. To obtain a refund or a replacement, return the product to the place of purchase.
Remark: Modifications not authorized by the manufacturer may void users authority to operate this device. NOTE: This equipment has been tested and found to comply with limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction.