User's Manual

2 598-1135-00
DRAFT COPY
Features and Ratings:
• Rated for 120VAC/60Hz supply voltage.
• Up to 300 Watt maximum incandescent load.
• Not for use with Compact Fluorescent bulbs.
• Up to 100 feet (30 m) typical transmission range.
• Fits standard single gang junction box.
Important: This product can not be used if more than one switch
is being used to control the light.
Important: Never install two wall switch receivers within 3 feet
(0.9 m) of each other. This may reduce the operating range.
WALL SWITCH RECEIVER
Installation
1. Locate light switch to be replaced by wall switch receiver.
2. Turn off the power to the light switch circuit before you
proceed. Do this at your circuit breaker or fuse box.
3. Remove the existing wall plate and switch. Disconnect the
two power wires and the ground wire.
Note: If there are more than two power wires attached to the
switch, consult an electrician about installation. In addition,
some local building codes may require installation by a qualified
electrician.
4. Connect one of the black power wires from receiver to one
of the power wires you removed from the old switch. Use one
of the supplied wire connectors to secure the wires (see
illustration).
5. Connect the second black power wire from receiver to the
other power wire you removed from the old switch. Use one
of the supplied wire connectors to secure the wires (see
illustration).
6. Connect the green ground wire from receiver to the ground
wire removed from old switch. Use one of the supplied wire
connectors to secure the wires (see illustration).
7. Check wire connections to make sure they are secure and
that no bare wires are exposed.
8. Position the wall switch receiver in the junction box with the
DIM button located to the right. Use the two wall switch screws
(long) supplied to mount the receiver to the wall box (see
illustration). Push excess wiring into wall box while you do this.
You may need to bend the wires to fit inside the box. Mount
wall plate on wall switch receiver with screws (short) provided.
Installing Wall Switch Receiver
9. Turn on the power to the light switch circuit. Do this at your
circuit breaker or fuse box.
Wall Switch
Screw
Ground Wire
(Bare or
Green)
Junction
Box
Wall Switch
ON/OFF
Button
DIM Button
Power
Disconnect
Switch
Operation
1. Verify the power disconnect switch is in the ON (right side)
position.
2. Push the ON (top) button and release. The light should turn
on full bright. Note: If you are controlling a lamp, make sure
it is connected to the switched outlet and the lamp is
switched on.
3. Push the OFF (bottom) button and release. The light should
turn off.
4. Push either the top or bottom of DIM button and release. The
light should turn on at 50% brightness (or last setting).
5. Push and release top of DIM button to increase brightness.
Push and release bottom of DIM button to decrease bright-
ness. Note: There are 5 DIM settings ranging from 15% to
90% brightness.
6. Set desired DIM level. Note: DIM setting remembers last
setting used. To recall last DIM setting, push and release
either the top or bottom of DIM button.
Note: The DIM setting defaults to 50% in the event of a power
failure.
Bulb Replacement
Move the power disconnect switch to the OFF (left side) position.
Replace bulb(s).
Caution: Do not exceed the maximum load limits listed above.