User's Manual

4 598-1135-00
DRAFT COPY
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
1. Circuit breaker or fuse is turned off.
2. Switch on device is turned off.
3. Interrupted by another device.
4. Does not respond immediately after
installation.
5. Device is defective.
6. Signals from transmitter are being
blocked, or transmitter is out of range.
7. Weak battery in the transmitter.
8. Dip switches on transmitter and re-
ceiver units do not match.
1. Same as 6, 7, and 8 above.
1. Short term power line failure.
2. Another transmitter on the same
channel.
SYMPTOM
Device does not come on.
Device does not turn off.
Device comes on randomly.
SOLUTION
1. Verify circuit breaker or fuse is
turned on.
2. Verify switched device is turned on.
3. Change channels on transmitter and
receiver units.
4. Wait for 90 second initialization
period (remote motion sensor).
5. Test using different device.
6. Check for metal objects that could
block the signal, or reposition the
transmitter.
7. Check battery charge and replace if
necessary.
8. Verify dip switch settings on trans-
mitter and receiver units are set the
same.
1. Same as 6, 7, and 8 above.
1. Short term power line failure.
2. Change channels on transmitter and
receiver units.