Owner's Manual

4 598-1116-04
ADD-A-SWITCH
Installation
1. Remove Tab from Battery Chamber. Remove cover
from front of Add-A-Switch transmitter. Gently pull
tab out of battery chamber. Slide cover onto Add-A-
Switch transmitter.
DIM
Add-A-Switch
Add-A-Switch
ON/OFF
Button
DIM
Button
Access Door
D
I
M
Removing Battery Tab
1 2
ON
2032
3
V
L
i
t
h
i
u
m
B
a
t
t
e
r
y
Battery Chamber
(Type CR2032)
Access Door
Tab
1 2 3 4
ON
DIM
2032
3
V
L
i
t
h
i
u
m
B
a
t
t
e
r
y
CR2032
Lithium
Battery
Battery
Locking
Tab
Access
Door
Removing Access Door
and Battery
5. Continue to press the DIM button until the desired dim level is
reached. Note: Receiver remembers last DIM setting used. To
recall last DIM setting, push and release the DIM button.
Note: The DIM setting defaults to 50% in the event of a power
failure.
Important: Wait 1 to 2 seconds after you press a transmitter
button before you press it again to allow the transmission to be
completed.
Note: If light does not turn on or intermittently turns on and off when
transmitter buttons are pushed, see Troubleshooting Guide .
Battery Replacement
The wall switch transmitter requires a type CR2032, 3-volt
lithium battery to operate. The transmitter is shipped with the
battery installed. With typical use, the battery will last approxi-
mately 5 years. Remove battery when transmitter will not be
used for an extended period of time.
1. Place thumb on access door and slide down to open.
2. Carefully bend locking
tab outward. Battery will
pop up.
3. Remove battery from
socket.
4. Install replacement bat-
tery in socket plus (+)
side up (see illustra-
tion). Press down on
battery until locking tab
snaps into place.
5. Reinstall access door
by sliding it upward un-
til it locks in place.
2. Select mounting location for add-a-switch transmitter. Note:
Transmitter should be located within 100 feet (30 m) of receiver.
Note: Transmitter should be mounted approximately 4 feet
from the floor and in the vertical position.
3. Before mounting, hold transmitter in selected location and
verify operation (see Operation ). Note: If transmitter does
not operate correctly, see Troubleshooting Guide .
4. With transmitter held in place, mark the mounting holes with
a pencil or pointed object.
5. Remove transmitter and drill two 3/16" holes. Tap drywall
anchors (provided) into holes with a hammer.
6. Attach transmitter to wall using two screws (provided).
Operation
1. Verify that receiver has been properly installed. See Re-
ceiver Information, page 7.
2. Push the ON (top) button and release. The light should turn
on full bright.
3. Push the OFF (bottom) button and release. The light should
turn off.
4. Push the DIM button and release. The light should turn on at
a DIM level.