Owner's Manual

7 598-1116-04
ENGLISH
RECEIVER INFORMATION
All receivers have the following features and ratings:
• Rated for 120VAC/60Hz supply voltage.
• Light can be dimmed when used with remote control (OFF, 5
Selectable Dim Levels from Dimmest to Brightest, Full On).
• Remembers last selected dim setting.
• Not for use with Compact Fluorescent bulbs.
•When first turned on wait 15 seconds.
INDOOR PLUG-IN CONVERTER
Features and Ratings:
• Up to 300 Watt maximum incandescent load.
• No wiring required.
1. Plug in indoor receiver.
2. Plug in light you wish to control.
Caution: Do not exceed the maximum load limits listed
above.
3. Check operation. Activate transmitter being used with re-
ceiver (see transmitter instructions). A signal will be sent to
the receiver to turn the receiver ON or OFF.
4. Using Remote By-Pass Switch. These receivers are equipped
with a remote by-pass switch. This switch allows the user to
select between AUTO and MANUAL modes. AUTO mode
allows the light to be operated by remote control or remote
motion sensor. MANUAL mode allows the plugged in light to
be operated manually.
5. Adjust audio alert volume (if applicable). Some models are
equipped with an audible alarm. The alarm sounds only
when the receiver is activated by the wireless motion sensor
and entry switch. The alarm volume is adjusted by the
thumbwheel on the side of the receiver unit.
Control Locations
Remote
By-Pass
Switch
Remote
By-Pass
Switch
Alarm Volume
ControlSpeaker
Maximum
Coverage Angle
Maximum Range
Coverage Area
Motion Sensor Sensitivity
The detector is most sensitive to motion across its field of view.
Motion Sensor Controls - Bottom View
Motion
Most SensitiveLeast Sensitive
Motion
Sensor Sensor
51TEST
ON-TIME
(MINUTES)
RANGE
MAX
MIN
ON-TIME
Control
Sensitivity
Control
LED
Indicator
70 ft.
(21 m)
8 ft.
(2.4 m)
180°
Aim Sensor Down
for Short Coverage
Aim Sensor Higher
for Long Coverage
Adjusting Motion Sensor Coverage