User's Manual

Page 3
598-1004-03
Indoor Module Operation
1. Install the Indoor Module as shown.
Indoor Module
2. Plug in the device(s) you wish to
control. Caution: do not exceed
the specifications listed on the next
page. Turn the device on.
3. To check the operation, press the right side button on the
transmitter. The light/appliance should turn on immediately.
Important: Wait at least 3 seconds after you press the transmit-
ter button before you press it again to allow the transmission to
be completed.
Note: The SL-6132 system works with other Heath
®
/Zenith wireless
switch products with the same channel designation ('F', 'G', 'H').
SPECIFICATIONS
Range . . . . . . . . . . . . . . . Up to 50 feet (15.2 M)
Rated Voltage . . . . . . . . . 120 VAC, 60 Hz
Battery . . . . . . . . . . . . . . . 9-volt alkaline
SL-6139 SL-6136
Max. Load, resistive ................ 13 A................................. 5 A
tungsten ................................. 960 W ............................ 500 W
fluorescent.............................. 960 W ............................ 300 W
motor .....................................1/3 H.P........................... 1/3 H.P.