User's Manual

-3-

598-1123-00

Tune Settings

Your wireless chime has different selectable tunes: Ding (one note) and Ding-

Dong (two note). The factory setting is for the Ding-Dong tune. This tune can

be changed by following the instructions below.

• Ding (one note tune)

In Push Button Only - Set dip switch 8 to “ON” position or add jumper.

• Ding-Dong (two note tune)

In Push Button Only - Set dip switch 8 to “OFF” position or remove jumper.

Note: All Heath

/Zenith models have both front and back door tune capabili-

ties. We recommend the back door use the Ding tune and the front door use

the Ding-Dong tune. Models that include two push buttons will come factory

set for front and back doors. Decals on the rear of the push button will indi-

cate its setting.

Replacing Push Button Batteries

Install two lithium type CR1220 3 volt

batteries. See diagram inside push but-

ton for correct orientation of batteries.

Rear of Chime

1 2 3 4 5 6 7

Figure 4

1 2 3 4 5 6 7 8

Inside Push

Button

* Code Settings 1-

7 Must Match Both

Push Button and

Chime

Tune Setting

(+) Positive

Battery

Terminal

Insert Batteries (+)

Positive Side Up

Note: Some models might require the use of

tweezers to remove and replace the jumpers

or a small screwdriver to set dip switches.