Installation and Operating Instructions

6 210267-01
Note: When rst turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
* resets to Auto Mode at dawn.
Mode: On-Time Works: Day Night
Test
5 Seconds x x
Auto
1, 5, or 10 Minutes x
Accent
3, 6 Hour, To Dawn x
Manual
To Dawn* x
CARE AND MAINTENANCE
• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light xture. ey could cause a premature deterioration
of the nish. is is not a defect in the nish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
Oine Operating Modes
• Motion Sensor (AUTO) – is light xture is designed
to automatically turn on when the sensor detects a tem-
perature dierence moving across the front of the motion
sensor. e light will turn o automatically after a set
amount of time. e ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Optional DualBrite® Control – “DualBrite” mode is a
selectable feature within the app that turns the light on at
a reduced (accent) level at dusk. When motion is detected,
the light will increase to full bright for the amount of the
”Full Brite Setting” (1, 5, or 10 minutes) then returns to
“DualBrite” mode. e light will stay on at the reduced
light level for the amount of time selected (O, 3 hr., 6
hr., dusk-to-dawn) and then turn o completely. Once
the “DualBrite Time” runs out, the light will turn ON
only when motion is detected. Selecting OFF disables the
“DualBrite” feature, however the motion sensing features
will continue to work.
RESET BUTTON
is light can be reset to the original factory settings either
by using the reset button on the bottom of the sensor or
through the HZconnect app. Note: After resetting the light,
it may take up to 5 minutes for the light to be removed from
the HZconnect app.
• Reset Button – Use a paper clip to press the RESET
button for 15 seconds to reset the light.
For additional information concerning this light or the
HZconnect app , visit www.heath-zenith.com/HZconnect.
SPECIFICATIONS
Motion Sensing Range ...................................... Up to 30 ft. (9.1 m) [varies with surrounding temperature]
Motion Sensing Angle ......................................Up to 180°
Electrical Load ..................................................Up to 100 Watt Maximum Incandescent
Bulb Type ..........................................................Medium Base, Type “A”, 100 Watt Maximum
Power Requirements ..........................................120 VAC, 60 Hz
Oine Operating Modes ..................................TEST and AUTO
ON-Timer ......................................................... 1, 5, 10 minutes (Night Only)
DualBrite Timer ................................................O, 3, 6 hours, dusk-to dawn (Night Only)
Test Timer ......................................................... 5 Seconds (Day and Night)