Manual

DO NOT ATTEMPT TO LIGHT THE BURNER BEFORE

GLOWING EMBER MATERIAL IS IN PLACE.

Step 1.

Loosely place glowing ember material under

the top burner as shown below.

NOTE:

It is imperative that enough ember

material be loosely placed at the top

of the middle burner to insure prop-

er ignition of ember bed.

NEVER PACK OR ADD ANY

MATERIAL ON THE BURNER

OTHER THAN WHAT IS SUP-

PLIED WITH YOUR SYSTEM .

WARNING

Failure to position the supplied material in accordance with these

instruction or failure to use only the materials supplied specifically with

this heater may result in property damage or personal injury.

PLACING GLOWING EMBER MATERIAL.

Step 2. Place glowing ember material along the sides of the middle burner. Place

glowing embers along the sides of the bottom burner, all the way across.

All previously applied loose material must be removed prior to reapplication.

Apply all loose material per instruction manual. DO NOT apply extra material

or material not supplied with heater. Replace only with Thermafiber, Granulated HP. Part No.

F-EMBERS.

WARNING