Manual

INSTALLATION INSTRUCTIONS

HFB-B BLOWER ASSEMBLY

The HFB-B blower is an option for certain fireboxes manufactured by Heatmaster, LLC. Do not install an

HFB-B blower in any firebox unless the instructions provided with that firebox specify that is designed for

HFB-B blower. Usage of an improper blower could lead to personal injury or property damage. Check with

your firebox dealer if you are unsure about usage of this blower in your firebox.

These instructions should be read before installing the blower, used as a guide, and kept for future reference.

To properly install the HFB-B blower, please follow directions below. Before the blower is installed, a JB1

Junction Box must be installed and wired according to the wiring diagram shown below.

HFB-B WIRING DIAGRAM

NOTE: THE JB1 JUNCTION BOX SHOULD BE INSTALLED AND THE RECEPTACLE WIRED TO

THE ELECTRICAL SYSTEM OF THE STRUCTURE AT THE TIME OF INSTALLATION OF

THE FIREBOX IF THE HFB-B BLOWER IS TO BE USED.

Wiring must be performed by a qualified person in a manner to conform with the National Electrical Code

ANSI/NFPA 70 and all applicable local codes. This blower should be on a 10 amp circuit (minimum).

CAUTION: ALWAYS CHECK AND MAKE SURE POWER IS OFF BEFORE ATTEMPTING TO

INSTALL OR SERVICE ANY ELECTRICAL WIRING OR COMPONENTS.

CONTINUED ON NEXT PAGE

16-1603 07/2013

PAGE 1
INSTALLATION INSTRUCTIONS HFB-B BLOWER ASSEMBLY The HFB-B blower is an option for certain fireboxes manufactured by Heatmaster, LLC. Do not install an HFB-B blower in any firebox unless the instructions provided with that firebox specify that is designed for HFB-B blower. Usage of an improper blower could lead to personal injury or property damage. Check with your firebox dealer if you are unsure about usage of this blower in your firebox.
PAGE 2
BLOWER INSTALLATION Remove the cover plate from your firebox by removing screws as illustrated below. Install HFB-B blower as shown. Plug blower’s cord set into receptacle of JB1 junction box, and reinstall screws to secure blower to firebox. NOTICE: Blower motor is permanently lubricated; it does not require oiling. Replace with HFB-B blower assembly by first plugging power cord into receptacle located to the right under the hearth pan.
PAGE 3
HEATMASTER, LLC. LIMITED WARRANTY All refractory cement logs manufactured by Heatmaster LLC. have a lifetime warranty against breakage due to heat to the original owner in the original installation. All other logs supplied from Heatmaster LLC. have a 2 year warranty against breakage due to heat to the original owner in the original installation. All metal parts, including burners and grate assemblies, are warranted for 5 years. All other mechanical parts are warranted for 1 year. LIMITATIONS 1.