Manual

FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance is equipped with a push button piezo ignition device, which can be used to light the pilot. If the piezo
fails to ignite the pilot, then follow the instructions for lighting pilot with match.
B. BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas
is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
♦ Do not try to light any appliance.
♦ Do not touch any electrical switch; do not use any phone in your building.
♦ Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
♦ If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by
hand, do not try to repair it. Call a qualified service technician. Force or attempted repair may result in fire or
explosion.
D. Do not use this room heater if any part has been under water. Immediately call a qualified service technician to inspect
the room heater and replace any part of the control system and any gas control that has been under water.
LIGHTING INSTRUCTIONS
1.STOP! Read the safety information previously listed above.
2. Turn main gas control knob (FIG. 7) clockwise  to the “OFF” position.
3. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP!
Follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step.
4. Locate pilot - mounted on the inside of the right hand bracket that holds the burner in place, just behind the front part
of the burner. (FIG. 6)
5. Depress main control knob (FIG. 7) and turn counterclockwise  to the “PILOT” position. With main control
knob (FIG. 7) at “PILOT”, depress until it stops and press on the igniter push-button several times. (FIG. 7) This will
cause a spark at the pilot burner, which will ignite the pilot flame. Continue to hold the main control knob (FIG. 7) in
for about (1) minute after the pilot is lit. Release knob and it will pop back out. Pilot should remain lit. If it goes out,
repeat steps 1 through 5.
♦ If the knob does not pop out when released, stop and immediately call your service technician or gas supplier.
♦ LIGHTING PILOT WITH MATCH: Turn main control knob (FIG. 7) to the “PILOT” position. Place a lit match at
the pilot burner, then push the main control knob in. Continue to hold the control knob in for about one (1) minute
after the pilot is lit. Release knob and it will pop back out. Pilot should remain lit. If it goes out, repeat the above step.
♦ If the pilot will not stay lit after several tries, turn the gas control knob (FIG. 7) to “OFF” and call your service
technician or gas supplier.
6. Depress main control knob (FIG. 7) and turn counterclockwise  to the “ON” position. Adjust heat output to the
desired level by turning the HI/LOW control knob.
TURN OFF GAS TO APPLIANCE
Turn main gas control knob (FIG. 7) clockwise  to the “OFF” position. Do not force.
WARNING: If you do not follow these instructions exactly a fire or explosion may result causing property
damage, personal injury, or loss of life.
PILOT BURNER
IGNITOR
Page 15
MILLIVOLT