Manual

ManualsBrandsHeatmaster ManualsFireplace/Gas Stove Accessories42" Vent Free Builder Firebox with Multi Pattern Brick Liner in Black

IM-147

CAREFULLY REVIEW THE INSTRUCTIONS SUPPLIED WITH THE

DECORATIVE TYPE UNVENTED ROOM HEATER FOR THE MINIMUM

FIREPLACE SIZE REQUIREMENTS.

DO NOT INSTALL AN APPLIANCE IN THIS FIREBOX UNLESS

THIS FIREBOX MEETS THE MINUMUM DIMENSIONS REQUIRED

FOR THE INSTALLATION.

INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.

CONSUMER: RETAIN THIS MANUAL FOR FUTURE

VENT-FREE FIREBOX

MODEL: HVF36-BB & HVF42-BB

INSTALLATION, OPERATION AND MAINTENANCE MANUAL

FOR USE ONLY WITH LISTED GAS-FIRED UNVENTED DECORA-

TIVE ROOM HEATER NOT TO EXCEED 40,000 BTU/HR.

DO NOT BUILD A WOOD FIRE.

WARNING: If the information in this manual is not followed exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

10/2016

Summary of content (9 pages)

PAGE 1
VENT-FREE FIREBOX MODEL: HVF36-BB & HVF42-BB INSTALLATION, OPERATION AND MAINTENANCE MANUAL FOR USE ONLY WITH LISTED GAS-FIRED UNVENTED DECORATIVE ROOM HEATER NOT TO EXCEED 40,000 BTU/HR. DO NOT BUILD A WOOD FIRE. . CAREFULLY REVIEW THE INSTRUCTIONS SUPPLIED WITH THE DECORATIVE TYPE UNVENTED ROOM HEATER FOR THE MINIMUM FIREPLACE SIZE REQUIREMENTS. DO NOT INSTALL AN APPLIANCE IN THIS FIREBOX UNLESS THIS FIREBOX MEETS THE MINUMUM DIMENSIONS REQUIRED FOR THE INSTALLATION.
PAGE 2
SAFETY CODES AND STANDARDS The design of this firebox has been tested and approved by the C.S.A. in accordance with ANSI Z21.91b-2007 UNVENTED FIREBOX ENCLOSURES FOR GAS-FIRE UNVENTED DECORATIVE ROOM HEATERS. This firebox is UNIVERSALLY LISTED for use with the compatibly sized decorative type unvented room heaters, which comply with standard Volume II Z21.11.2 of the American National Standards Institute. This manual serves only as a basic guideline for installation of this firebox and gas piping.
PAGE 3
ATTENTION INSTALLER: 1. Attach with fasteners the label that was supplied with the unvented fireplace insert to the inside of the solid-fuel burning fireplace or listed unvented firebox enclosure into which the unvented fireplace insert is installed. 2. DO NOT cut any sheet metal parts of the solid-fuel burning fireplace or listed unvented firebox enclosure in which the unvented fireplace insert is to be installed. 3. If the factory-built fireplace has no gas access hole(s) provided an access hole of 1.
PAGE 4
CLEARANCES COMBUSTIBLE SIDE WALL INSTALLATION HVF36-BB COMBUSTIBLE SIDE WALL PLACEMENT FOR HVF36-BB & HVF42-BB COMBUSTIBLE SIDE WALL INSTALLATION HVF42-BB GUIDELINE DIMENSIONS FOR CORNER APPLICATION HVF36-BB HVF42-BB 4
PAGE 5
FIREBOX & FRAMING DIMENSIONS HVF42-BB HVF36-BB Fireplace Model # Inner Dimensions Height of rear wall Width of front opening Width of rear wall Depth Fireplace Model # Framing Dimensions HVF36BB HVF42BB 22” 22 1/2” 29 1/2” 35 1/2” 25” 18 1/2” HVF36BB 25” 18 1/4” HVF42BB Framing dimension for Height 41 3/8” 41 3/8” Framing dimension for width 38 1/4” 44 1/4” Framing dimension for Depth 24 3/4” 24” 5
PAGE 6
MANTELS, SURROUNDS & TRIM INSTALLATION The firebox may be finished in an infinite number of ways from rustic to contemporary using marble, stone, wood, brick, tile or various other natural or man-made materials. CAUTION: THE BLACK PAINTED FACE OF THE FIREBOX (EXCLUDING NAIL FLANGES) MUST NOT BE COVERED WITH COMBUSTIBLE MATERIALS. SOME MAN-MADE BRICKS OR STONES MAY CONTAIN COMBUSTIBLE MATERIAL.
PAGE 7
GAS PIPING AND GAS PRESSURE REQUIREMENTS All gas piping must be installed to comply with local codes or, in the absence of local codes, with the latest edition of the National Fuel Gas Code ANSI 223.1/NFPA 54. Unions in gas lines shall be of the ground joint type. Compounds used on threaded joints of gas piping must be resistant to the action of liquefied petroleum gas. Gas piping must be of sufficient size to provide a minimum natural gas pressure at the appliance of 7” water column or 11” for LP gases.
PAGE 8
ORDERING PARTS Replacement parts for your firebox can be obtained from your local dealer. Should you need additional information beyond what your dealer can furnish contact; Heatmaster, LLC./American Gas Log, LLC. Angier, N.C. 27501 (919) 639-4568. WHEN ORDERING PARTS, SPECIFY: 1. Firebox model number. 2. Component model number (if known). 3. Part number and key number. 4. Part name and quantity. HVF36-BB & HVF42-BB THERMODISC IS LOCATED INSIDE FIREBOX KEY NO.
PAGE 9
OPTIONAL ACCESSORIES: HEATMASTER, LLC/AMERICAN GAS LOG, LLC.. HFB-B BLOWER KIT IS AVAILABLE FOR USE WITH THIS FIREBOX. INSTALLATION INSTRUCTIONS ARE PROVIDED WITH EACH HFB-B BLOWER KIT. DO NOT USE ANY OTHER BLOWER KIT WITH THIS FIREBOX. THE LOCATION OF THE COVER PLATE (ITEM 5) ON THE FIREBOX’S HEARTH MUST BE REMOVED TO INSTALL THE BLOWER. SAVE THE SCREWS THAT WAS USED TO SECURE THE COVER PLATE AND USE THEM TO INSTALL THE BLOWER. THE BLOWER SHOULD BE INSTALLED DURING INSTALLATION OF THE FIREBOX.