Instructions / Assembly

The heater is designed for use as a construction heater in accordance with ANS
Z83.7b-2009/CSA2.14b-2009. Other standards govern the use of fuel gases and
heating products for speci
c uses. Your local authority can advise you about these.
The primary purpose of construction heaters is to provide temporary heating of
buildings under construction, alteration or repair. Properly used, the heater provides
safe economical heating. Products of combustion are vented int
o the area being heated.
W
fire safety authority if you have questions about heater use.
e cannot foresee every use which may be made of our heaters.
Other standards govern the use of fuel gases and heat producing products for
speci
c uses. Your local authorities can advise you about these.
carbon monoxide poisoning resemble theu, with headaches, dizziness and/or
nausea. If you have these signs, the heater may not be working properly.
For proper ventilation to be used in arcas with.
Propane gas is odorless. An odor making agent is added to propane gas. The
odor helps you detect a propane gas leak. However,the odor added to propane gas
can fade. Propane gas may be present even though no odor exists.
Make certain you read and understand all warnings. Keep this manual for reference.
It is your guide to safe and proper operation of this heater.
1.
2. U
The installation must conform with local codes or, in the absence of local codes, with the
Standard for the Storage and Handling of Liquefied Petroleum Gases, ANSI/NFPA 58
and the Natural Gas and Propane Installation Code, CSA B149.1.
se only the electrical voltage and frequency speci
ed on model plate. The
electrical connections and grounding of the heater shall follow the National
Electric Code, ANSI/NFPA 70 or the Canadian Electrical Code, Part 1.
3. Electrical Grounding Instructions -This appliance i
s equipped with a three-prong
(grounding) plug for your protection against shock hazard and should be plugged
directly into a properly grounded three-prong receptacle or extension cord.
4. The hose assembly shall be visually inspected prior to each use of the heater. If it is
evident there is excessive abrasion or wear, or the hose is cut, it must be replaced prior
to the heater being put into operation. The replacement hose assembly shall be that
specified by the manufacturer.
5. Use only propane gas set up for vapor withdrawal.
6. SRCH11011 for indoor and outdoor use. SRCH11033 for indoor use only.
Provide adequate ventilation.
7. Do not use heater in occupied dwellings or in living or sleeping quarters.
4
SAFETY INFORMATION CONTINUED
Check with your local
Carbon Monoxide Poisoning:
Propane Gas:
Save areas can be affected by carbon monoxide more than others. Early signs of