Owner Manual

SET UP AUTO OFF FUNCTION

The relay comes with an option to program in an Auto-Off function.

The factory default auto off is disabled to begin with.

The Auto-Off is active all the time once programmed. To change it, you’ll need access to the relay and to go

through this program again.

2. To enter Setup menu, press both buttons for 2 sec-

onds

Menu Set

1. Start, Relay needs to be in either of the two modes

solid

1 1

4. Press the Menu button four times quickly

3. Relay is ready to accept change of Menu

4 1

5. The Menu button will continue to flash 4 times, as

long as you are in this function.

6. To select an option,

press the set button, the

number of times in the

table. The set button

will flash amber to the

corresponding time peri-

7. Confirm option by holding down Set button for 2 seconds

Flash

9. To exit back to Start

solid

10. System will be OFF and ready to operate

8. The set button will flash the number of times corre-

sponding with the time chosen