Installation & Assembly

ASSEMBLY INSTRUCTIONS

NOTE: IF USING A SIDE MOUNT SETUP, SKIP TO STEP 5.

STEP 1

Attach the Support Uprights (GG) to the Base

Plate (FF) using the Round Head Bolts (A),

Washers (G), and the Round Head Nuts (N).

STEP 2

Make sure the spa is empty and slide the Base

Plate/Support Upright assembly under the center

of the back of the spa cabinet. This will be the

side the spa cover will be stored behind. Make

sure the Base Plate (FF) sits at on the ground,

with no overhang off the slab or deck.

Figure 3

NOTE: IF YOU ARE USING A SIDE MOUNT SETUP, SKIP TO STEP 6

2. Attach the ccGG Support Legs to the ccFF Base Plate using the ccA Round Head Bolts, the ccG Washers,

and the ccN Round Head Nuts. See Fig 2.

Figure 2

3. Make sure the spa is empty and slide the Base Plate/Support Leg assembly under the center of the back of

the spa cabinet. This will be the side the spa cover will be stored behind. Ensure the ccFF Base Plate sits flat

on the ground, with no overhang off the slab or deck. See Fig 3.