OWNER’S MANUAL ONE-PERSON & TWO-PERSON SAUNAS WITH CERAMIC OR CARBON HEATERS SA2400/SA2402/SA2406/SA2409/SA1309
TABLE OF CONTENTS ASSEMBLY TIPS & WARNINGS 3 PARTS IDENTIFIER 4 ASSEMBLY INSTRUCTIONS 5-10 OPERATION INSTRUCTIONS 11 ENJOYING YOUR SAUNA 12 HEALTH & SAFETY WARNINGS 13 CLEANING & MAINTANENCE 14 TROUBLESHOOTING GUIDE 14-15 REPLACEMENT PARTS 16-25 WARRANTY INFORMATION 26 The information contained in this manual is subject to change without notice.
ASSEMBLY TIPS & WARNINGS • Before you begin, read all assembly instructions and safety warnings carefully. • This sauna requires at least 2 adults to complete assembly. • Remove all of the contents from boxes and verify that you have all of the parts shown on the Parts Identifier before you begin assembly. Note: Some parts may be pre-installed or pre-assembled. • This manual is used for the assembly of several sauna models; therefore, some figures or drawings may not look exactly like your product.
PARTS IDENTIFIER (NOT TO SCALE) * Refer to REPLACEMENT PARTS (PAGE 16-25) to determine the correct part number when ordering replacements.
ASSEMBLY INSTRUCTIONS 1. Begin assembly by determining an appropriate location for your sauna – see ASSEMBLY TIPS & WARNINGS for details. Attach the BACK PANEL to the FLOOR by lining up the BACK PANEL with the groove in the back of the FLOOR. 2. Attach the LEFT PANEL to the FLOOR. Buckle the LEFT PANEL to the BACK PANEL. 3. Attach the RIGHT PANEL to the FLOOR. Buckle the RIGHT PANEL to the BACK PANEL.
ASSEMBLY INSTRUCTIONS (CONT.) 4. Carbon Heater Models Only: Attach the FLOOR HEATER to the FLOOR with 1-1/2” SCREWS. Connect the heater plug. 5. Slide the BENCH HEATER PANEL into place between the LEFT and RIGHT PANELS. Connect the heater plug. Note: For Carbon Heater Models, make sure the FLOOR HEATER cable is placed through the groove in the bottom of the BENCH HEATER PANEL. 6. Attach BENCH SEAT with 2” SCREWS.
ASSEMBLY INSTRUCTIONS (CONT.) 7. Ceramic Heater Models Only: Attach BACK PANEL HEATER COVER to BACK PANEL with 2” SCREWS and to BENCH SEAT with 3/4” SCREWS. 8. Attach the FRONT PANEL to the FLOOR. Buckle the FRONT PANEL to the LEFT and RIGHT PANELS. 9. Lift the ROOF above the sauna, feeding the control panel and heater cables through the corresponding holes. Feed the cables for the AM/FM CD PLAYER through the hole in the bottom of the ROOF.
ASSEMBLY INSTRUCTIONS (CONT.) 10. Feed the main power cable through hole in ROOF COVER. Secure the ROOF COVER with 3/4” SCREWS. 11. Attach the DOOR HANDLE to the GLASS DOOR. 12. Gently pull the cables for the AM/FM CD PLAYER through the opening in the front of the STEREO SHELF. Attach the STEREO SHELF with 3/4” SCREWS.
ASSEMBLY INSTRUCTIONS (CONT.) 13. Plug the controller and antenna into the back of the AM/FM CD PLAYER. Note: The red and white cables are used for an optional video player and can be tucked out of the way. Slide and lock the AM/FM CD PLAYER into the STEREO SHELF. Note: Use “keys” with to remove the CD player for maintenance. 14. Attach the MAGAZINE RACK with 1-1/2” SCREWS. Note: A sticker indicates the optimal position for this accessory, but attaching it is optional.
ASSEMBLY INSTRUCTIONS (CONT.) 18. Two-Person Models Only: Remove the back cover of the OXYGEN IONIZER by turning is as indicated. Unwrap and install the fragrance patch, then reattach the back cover. Attach the OXYGEN IONIZER in the designated position with 3/4” SCREWS. Plug the power cable into the OXYGEN IONIZER. 19. Plug the main power cable into a dedicated outlet. Note: No other appliances should share the same outlet with this sauna. CONGRATULATIONS! The assembly of your sauna is now complete.
OPERATION INSTRUCTIONS SAUNA CONTROL PANEL Note: The sauna controls are the same for both the interior and exterior Control Panels. 1. Press POWER to turn ON the sauna. 2. Set the desired TEMPERATURE with the (+) and (-) buttons. 3. Press and hold both (+) and (-) to switch between °F (Fahrenheit) and °C (Celsius). 4. Set the desired TIME with the (+) and (-) buttons. 5. Press INSIDE or OUTSIDE to turn on or off the corresponding light. 6. When the TIME reaches 00, the heaters will turn OFF automatically.
ENJOYING YOUR SAUNA 1. Prior to initial use, wipe down all interior surfaces of the sauna with a damp cloth. 2. Turn on the sauna and set temperature to 104° F for one hour to burn off any factory dust. 3. Always drink plenty of water before, during and after your sauna session to stay properly hydrated. 4. A normal sauna session should last 30 minutes or less. 5. Allow approximately 10 to 15 minutes for the sauna to warm up before entering. 6.
HEALTH & SAFETY WARNINGS 1. Review all instructions and warnings before operating your sauna. A sauna is not a toy. Serious injury may result from negligence, intentional misuse and failure to follow safety instructions. 2. Hyperthermia Danger: Hyperthermia occurs when the body absorbs more heat than it can dissipate. When the elevated body temperatures are sufficiently high, hyperthermia is a medical emergency and requires immediate treatment to prevent disability or death.
CLEANING & MAINTENANCE 1. Always unplug the sauna and allow it to cool down before performing any cleaning or maintenance. 2. Use furniture polish or furniture oil when cleaning the sauna exterior. 3. The sauna interior surfaces should only be wiped down with a damp cloth. Do NOT use chemicals, abrasive cleaners or solvents on the unfinished interior wood. 4. As with all natural wood products, variations in the color and the grain as well as irregularities such as knots and fine cracks may be present.
TROUBLESHOOTING GUIDE (CONT.) Problem THE CONTROL PANEL DOES NOT WORK Solution 1. Check that all the connections are tight. 2. If the numbers are scrambled or the buttons are unresponsive, replace the Control Panel. 3. If the temperature indicator does not work or reads “--” or “EP”, replace the Control Panel with Temperature Sensor. Problem THE LIGHTS ARE NOT WORKING 1. Check that all the connections are tight. Solution 2. If one light does not work, replace the bulb.
REPLACEMENT PARTS In the event that you need replacement parts, locate your sauna model in the guide below to reference the correct part numbers. It is important to use only the replacement parts specified by the manufacturer. The use of unauthorized substitutes may damage your sauna or cause electrical hazards resulting in injury or fire.
SA2400 17
REPLACEMENT PARTS (CONT.
SA2402 19
REPLACEMENT PARTS (CONT.
SA2406 21
REPLACEMENT PARTS (CONT.
SA2409 23
REPLACEMENT PARTS (CONT.
SA1309 25
SAUNA WARRANTY REGISTRATION CARD 1. This sauna has a 5-Year Warranty against defects in materials and workmanship. To receive the warranty, the card must be filled out completely and returned. This 5-Year Warranty covers the sauna. The radio in your sauna is covered by a limited 1-Year Warranty. 2. Please notify Blue Wave Products in advance of any sauna warranty claim prior to shipping the sauna back. Contact our warranty claim department at warranty@splashnetxpress.com. 3.