User's Manual

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
CFR 47 FCC PART 15 SUBPART C has been investigated. It is applicable to the modular transmitter
2.3 Specific operational use conditions
This module is stand-alone modular. If the end product will involve the Multiple simultaneously transmitting condition or different
operational conditions for a stand-alone modular transmitter in a host, host manufacturer have to consult with module manufacturer
for the installation method in end system.
2.4 Limited module procedures
This module is Limited single modular without shielding, host manufacturer have to consult with module manufacturer for the module
limiting conditions when integrate the module in the host. module manufacturer should reviews detailed test data or host designs
prior to giving the host manufacturer approval.
2.5 Trace antenna designs
Not applicable
2.6 RF exposure considerations
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
2.7 Antennas
This radio transmitter FCC ID:
2A2MNHCD-1220L1CON
has been approved by Federal Communications Commission to
operate with the
antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list
that have a gaingreater than the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Model Type Connector
Peak gain ( dBi )
2400-
2500MHz
5150-5250
MHz
5250-5350
MHz
5470-5725
MHz
5800
MHz
BLE
PCB
/
0 dBi
/ / / /
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following" Contains FCC ID:2A2MNHCD-1220L1CON".
2.9 Information on test modes and additional testing requirements
Host manufacturer which install this modular with limit modular approval should perform the test of radiated emission and spurious
emission according to FCC part 15C:15.247 and 15.209 requirement, only if the test result comply with FCC part 15.247 and
15.209 requirement, then the host can be sold legally.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all other applicable requirements for
the system such as Part 15 B.