Quick Start Guide

Q U I C K G U I D E
VOL. [dB] LINEARISER
®
CoP
-6
-12 +12
+6
0
-2
-4 +4
+2
0
LOW
-2
-4 +4
+2
0
HIGH
EXTEND.
(less SPL)
NORMAL
for SUB (80 Hz)
/MONO
/LEFT
ANALOG
RIGHT
-4 +4
0
-10
SMALLLARGE
OFF
MED.
ON
OFF
(*)
Ported
Closed
SHELVING FILTER [dB] LF RANGE
ANALOG/AES INP. SENS. [dB] DESK FILTER
ALL "0" and "↑" POSITION = FACTORY SETTING
ANALOG IN AES IN AES THROUGH
1
2
3
5
6
4
7
8
9
10
11
12
1. Volume
/ adjust the output volume
2. HEDD Lineariser®
/ activate or deactivate the HEDD Lineariser® for full phase linearity
3. CoP
/ change the DSP settings according to whether you are using the
speakers ported (without plug) or closed (with plug)
4. Low shelf filter
/ changes bass response in a ± 4 dB range in 1 dB steps to adapt the
speakers to your room
5. High shelf filter
/ changes treble response in a ± 4 dB range in 1 dB steps to adapt the
speakers to your room
6. Low frequency range
/ optionally extend the bass range (at the expense of a lower max. SPL)
or optimized for use as satellite with subwoofers
7. Input selection
/ select your active input or stereo channel / please note that in analog
mode the stereo channel is dened by your pre-amp
8. Input sensitivity
/ adjust the input volume by increasing the input by up to 4 dB
(warning: clipping may occur) or lowering it by up to 10 dB
9. Desk filter
/ correct unwanted reections of desks and workspaces
10. Analog input
/ use this balanced XLR input connection to connect your HEDD
monitors with an analog balanced output amplier
11. Digital input
/ use this digital AES connection to connect your HEDD monitors
with a compatible source, for example a corresponding digital interface
12. Digital passthrough
/ use the AES output connection to pass through the input information,
for example to chain multiple speakers
Please download and read the full manual for more information.
1. Red: Overload
2. Green: Power On
3. White: Stand-By
LED INDICATORS