SDS

MATERIAL SAFETY DATA SHEET
Date Printed: 7/25/2012
Page 3 of 4
28-XXXX ALL COLORS - AEROSOL
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Not applicable.
EMERGENCY AND FIRST AID PROCEDURES:
INGESTION: If swallowed, do not induce vomiting. EYES: In case of eye contact, flush eyes immediately with plenty of
water for at least 15 minutes. SKIN: Wash effected area throughly with soap and water. INHALATION: If affected,
remove from exposure. Restore breathing. Keep warm and quiet.
=========== SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE ============
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Provide maximum ventilation. Only personnel equipped with proper respiratory and skin and eye protection should be
permitted in the area. Remove all sources of ignition. Take up spilled material with sawdust, vermiculite, or other
absorbent material and place into containers for disposal.
WASTE DISPOSAL METHOD:
Waste material must be disposed of in accordance with Federal, State, and Local environmental control regulations.
Empty containers should be recycled or disposed of through an approved Waste Management Facility.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
Do not store above 120 deg. F. Store large quantities in buildings designed and protected for storage of NFPA Flammable
liquids.
OTHER PRECAUTIONS:
If this material is part of a multiple component coating system, read the MSDS for the other component or components
before blending as the resulting mixture may have the hazards of all of its parts. Containers should be grounded when
pouring. Avoid free fall of liquids in excess of a few inchs. Containers of this material may be hazardous when
emptied since they retain residues. Do not cut, puncture, or weld on or near container.
===================== SECTION VIII - CONTROL MEASURES ======================
RESPIRATORY PROTECTION:
Overexposure to vapors may be prevented by ensuring ventilation controls, vapor exhaust or fresh air entry. If TLV of
any component is exceeded, use an appropriate NIOSH/MSHA approved respirator. Follow respirator manufacturers directions
for respirator use.
VENTILATION:
Provide sufficient general exhaust or local exhaust (preferred) ventilation to keep the concentration of ingredients
listed in Section II below the lowest exposure limits.
PROTECTIVE GLOVES:
Impermeable chemical handling gloves for skin protection.
EYE PROTECTION:
Wear safety glasses with unperforated side shields.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT:
Personal protective equipment for the body should be selected based on the task being performed and the risks involved.
WORK/HYGIENIC PRACTICES:
Eye washes and safety showers in the workplace are recommended.
========================= SECTION IX - TRANSPORTATION INFORMATION ==========
PROPER SHIPPING NAME HAZARD CLASS UN NUMBER PACKING GROUP
AEROSOLS,FLAMMABLE 2.1 UN1950
========================= SECTION X - DISCLAIMER ==========================