Operation Manual

HEIDENHAIN CNC PILOT 4290 131
4.3 The DIN PLUS Editor
Programming instructions
Instructions of the geometry menu
Below are the contents of the Instr. (instructions) menu group
DIN PLUS words:
U Select “Instr. > DIN PLUS words.” The editor opens the selection
box.
U Select the desired instruction for program structuring or the input/
output command.
Variable:
U Select “Instr. > Variables.” The editor opens the input line.
U Enter a variable or mathematical expression.
Program section codes:
Auxiliary contour:
U Select “Instr. > AUXILIARY CONTOUR.” The editor enters the code
in an appropriate position.
Front face, rear face or lateral surface contour:
U Select „Instr.> FRONT FACE“ (or „.. > LATERAL SURFACE“, „.. >
REAR FACE“)“. The editor opens the dialog for position input.
U Enter the position of the plane.
Comment:
U Select “Instr. > Comment line.” The editor opens the input line.
U Enter text. The comment is inserted above the position of the
cursor.
Instructions of the machining menu
Below are the contents of the Instr. (instructions) menu group