Manualshelf

Operation Manual

ManualsBrandsHeidenhain ManualsOtherCNC Pilot 4290
291292293294295296297298299300
294
4.29 Contour Follow-Up
4.29 Contour Follow-Up
Automatic contour follow-up is not possible with program branches or
repetitions. In these cases you control the contour follow up with the
following commands.
Saving/loading contour follow-up G702
G702 saves the current contour or loads a saved contour.
Program G702 for one slide.
Contour follow-up G703
G703 is used to deactivate the contour follow-up.
Parameters
Q Save/load contour
Q=0: Saves the current contour. The contour follow-up is
not affected.
Q=1: Loads the saved contour. The contour follow-up is
continued with the loaded contour.
Parameters
Q Contour follow-up on/off
Q=0: Off
Q=1: On