Operation Manual

412
6.6 Form Elements
Recess type D (sealing ring)
This form element defines an axial or radial recess on the outside or
inside of the contour. The recess is assigned to the previously
selected reference element.
Parameters
X Starting point for radial recess
Z Starting point for axial recess
I Diameter of recess base (only for axial recess)
Ii  Axial recess: Recess depth
 Radial recess: Recess width (pay attention to sign!)
Ki  Axial recess: Recess width (pay attention to sign!)
 Radial recess: Recess depth
Corners:
 No: No chamfer/rounding
 Chamfer: Chamfered edge
 Rounding: Rounded corner
B Width of chamfer or radius of rounding at both sides of the
recess
R Radius at bottom, inside radius in both recess corners