Operation Manual

526
6.14 Interactive Working Plan Generation (IWG)
Overview of milling operations
The IWG presents the following milling operations for selection
(“Milling” drop-down menu):
 Contour milling (see “Contour milling – Roughing/Finishing (G840)”
on page 527)
 Roughing
 Finishing
 Area milling (see “Pocket milling – Roughing/Finishing (G845/
G846)” on page 531)
 Roughing
 Finishing
 Deburring: see “Deburring (G840)” on page 529
 Engraving: see “Engraving (G840)” on page 530
 Automatic milling
 Roughing
 Finishing
The IWG machines the milling contours of the following reference
planes:
 STIRN [FRONT]
 RUECKSEITE [REAR SIDE]
 MANTEL [SURFACE]