Operation Manual

HEIDENHAIN CNC PILOT 4290 603
7.6 Machining Parameters
Load monitoring
11 – Load monitoring – General switches
12..19 – Load monitoring for machining modes
The first parameter switches load monitoring on and off. The other
parameters define the components to be monitored with regard to
machining location/machining mode.
Load monitoring – General switches
Load monitoring ON/OFF
 0 – OFF: TURN PLUS does not generate any commands for
load monitoring
 1 – ON: TURN PLUS generates commands for load
monitoring
Component positions
Corresponds to the parameter Q of G996:
 0: Monitoring not active
 1: Do not monitor rapid traverse
 2: Monitor rapid traverse
Load monitoring for machining modes
Inputs:
“Machining mode ...” ON/OFF:
 0: Load monitoring OFF
 1: Load monitoring ON
Components to be monitored (for more than one component,
sum of the component codes):
 0: No monitoring
 1: X axis
 2: Y axis
Components to be monitored (continued):
 4: Z axis
 8: Main spindle
 16: Driven tool
 32: Spindle 3
 64: Spindle 4
 128: C axis 1
12 Load monitoring for centric predrilling 16 Load monitoring for recessing
 Centric drilling ON/OFF
 Centering
 Drilling
 Boring
 Countersinking
 Reaming
 Tapping
 Recessing ON/OFF
 External
 Internal
13 Load monitoring for roughing 17 Load monitoring for thread cutting
 Roughing ON/OFF
 External/longitudinal
 External/transverse
 Internal/longitudinal
 Internal/transverse
 Thread cutting ON/OFF
 External
 Internal
 Transverse