Operation Manual

616
8.1 Tool Database
Drilling tool parameters
Example: Tool type 311
Parameters in dialog box 1 G S TP
ID: Tool ID number • • •
X, Z, Y dim. (xe, ze, ye): Setting dimensions • – –
Diamet. (db): Drill diameter • • •
Bor.ang. (bw): Drill angle • • •
Tip an. W (sw): Point angle • • •
Shnk.di. (d1): Shank diameter • • •
Shnk.ln. (l1): Shank length • • •
Pos.ang. (rw): Position angle • • –
X, Z, Y comp. (DX, DZ, DY): Compensation values
(maximum +/– 10 mm)
•––
Dir.rot.: Direction of spindle rotation • – •
Usab.lg.(nl): Usable length of drill – – •
Type of tap:
 0: Undefined
 11: Metric
 12: Fine-pitch thread
 13: Inch thread
 14: Pipe thread
 15: UNC
 16: UNF
 17: PG
 18: NPT
 19: Trapezoid thread
 20: Other
•–•
Strtlen (al): Length of first cut • • •
The “Type of tap” parameter is used for determining the
thread parameters; the AWG accounts for this parameter
when selecting a tool.