Operation Manual

716
Overview of G Commands in the CONTOUR Section
Overview of G Commands in the
CONTOUR Section
G commands for turning contours
G commands for C-axis contours
Turning contour Turning contour
Workpiece-blank definition Contour form elements
G20-Geo Chuck part, cylinder/tube Page 146 G34-Geo Thread (standard) Page 159
G21-Geo Cast part Page 146 G37-Geo Thread (general) Page 160
Basic Contour Elements G49-Geo Bore hole at turning center Page 162
G0-Geo Starting point of contour Page 147
Help commands for contour definition
G1-Geo Line segment Page 147 Overview:Help commands for contour
definition
Page 163
G2-Geo Circular arc with incremental center
dimensioning
Page 148 G7-Geo Precision stop ON Page 164
G3-Geo Circular arc with incremental center
dimensioning
Page 148 G8-Geo Precision stop OFF Page 164
G12-Geo Circular arc with absolute center
dimensioning
Page 150 G9-Geo Precision stop blockwise Page 164
G13-Geo Circular arc with absolute center
dimensioning
Page 150 G10-Geo Peak-to-valley height Page 164
Contour form elements G38-Geo Feed rate reduction factor Page 165
G22-Geo Recess (standard) Page 152 G39-Geo Attributes of overlay elements Page 165
G23-Geo Recess/relief turn Page 153 G52-Geo Blockwise oversize Page 166
G24-Geo Thread with undercut Page 155 G95-Geo Feed per revolution Page 166
G25-Geo Undercut contour Page 156 G149-Geo Additive compensation Page 167
C-axis contour C-axis contour
Overlapping contours Lateral surface contours
G308-Geo Beginning of pocket/island Page 168 G110-Geo Starting point of lateral surface
contour
Page 179
G309-Geo End of pocket/island Page 168 G111-Geo Line segment, lateral surface Page 179
Front and rear face contours G112-Geo Circular arc, lateral surface Page 180
G100-Geo Starting point of contour, face Page 172 G113-Geo Circular arc, lateral surface Page 180
G101-Geo Line segment, face Page 172 G310-Geo Bore hole, lateral surface Page 181
G102-Geo Circular arc on face Page 173 G311-Geo Linear slot, lateral surface Page 182
G103-Geo Circular arc on face Page 173 G312-Geo Circular slot on lateral surface Page 182
G300-Geo Bore hole, face Page 174 G313-Geo Circular slot on lateral surface Page 182
G301-Geo Linear slot, face Page 175 G314-Geo Full circle, lateral surface Page 183