Operation Manual

720
Overview of G Commands in the MACHINING Section
Synchronization commands
C-axis machining
Synchronization Synchronization
Assigning the contour to the operation Spindle synchronization, workpiece transfer
G98 Assignment spindle – workpiece Page 283 G30 Converting and mirroring Page 282
G99 Workpiece group Page 284 G121 Contour mirroring/shifting Page 202
Slide synchronization G720 Spindle synchronization Page 286
G62 One-sided synchronization Page 284 G905 Measuring C-angle offset Page 287
G63 Synchronous start of slides Page 285 G906 Measuring angular offset during
spindle synchronization
Page 288
G162 Set synchronizing mark Page 285 G916 Traversing to a fixed stop Page 288
Contour follow-up G917 Controlled parting using following error
(lag error) monitoring
Page 291
G702 Storing/loading contour follow-up Page 294 G991 Controlled parting using spindle
monitoring
Page 292
G703 Contour follow-up ON/OFF Page 294 G992 Values for controlled parting Page 293
G706 K default branch Page 295
C-axis machining C-axis machining
C axis Milling cycles
G799 Thread milling, axial Page 278
G119 Select C axis (No. of C axis) Page 253 G801 Engraving, face Page 279
G120 Reference diameter, lateral-surface
machining
Page 253 G802 Engraving, lateral surface Page 280
G152 Zero point shift, C axis Page 254 G840 Contour milling Page 261
G153 Standardize C axis Page 254 G845 Pocket milling, roughing Page 270
G846 Pocket milling, finishing Page 276
Face/rear-side machining Lateral-surface machining
G100 Rapid traverse, face Page 255 G110 Rapid traverse, lateral surface Page 258
G101 Linear path, face Page 256 G111 Linear path, lateral surface Page 259
G102 Circular arc, face Page 257 G112 Circular arc, lateral surface Page 260
G103 Circular arc, face Page 257 G113 Circular arc, lateral surface Page 260