Operation Manual

HEIDENHAIN MANUALplus 4110 211
4.8 Milling Cycles
Face milling
Call the milling menu.
Select the "Face milling" cycle.
Depending on the parameters, the cycle mills the following contours
on the face.
 One or two surfaces (Q=1 or Q=2, B>0)
 Rectangle (Q=4, L<>B)
 Square (Q=4, L=B)
 Triangle or polygon (Q=3 or Q>4, L>0)
 Circle (Q=0, RE>0, L and B: No input)