Operation Manual

268 5 ICP Programming
5.6 ICP Contour Elements on the Face
5.6 ICP Contour Elements on the
Face
Enter the dimensions of the contour elements on face and lateral
surface in Cartesian or polar values. You must pay attention to the
setting of the Polar soft key. MANUALplus distinguishes Cartesian
coordinates from polar coordinates by different address letters.
 Polar coordinates:
 XD, X: Diameter
 CS, C: Angle to positive XK axis
 Depending on the cycle, you can have the MANUALplus
display ICP contours for either the face or the lateral
surface by calling the "selection of ICP contours" with
the Contour list soft key.