Operation Manual

HEIDENHAIN MANUALplus 4110 273
5.7 ICP Contour Elements on the Lateral Surface
Entering lines on the lateral surface
Select the line direction.
You enter the dimensions of the line and then define the transition to
the next contour element.
Parameters
 ZS, YS starting point (YS as linear dimension—reference:
diameter XS)
 CS starting point as angular dimension
 XS unrolled diameter
 Z target point
 CY target point as linear dimension (reference: diameter XS)
 C target point as angular dimension
 L length of line
 F special feed
Select the line direction.
You enter the dimensions of the line and then define the transition to
the next contour element.
Parameters
 ZS, YS starting point (YS as linear dimension—reference:
diameter XS)
 CS starting point as angular dimension
 XS unrolled diameter
 Z target point
 CY target point as linear dimension (reference: diameter XS)
 C target point as angular dimension
 A angle to Z axis—for direction of angle, see graphic support
window
 L length of line
 F special feed
Vertical/horizontal lines
Line at angle