Operation Manual

398 6 DIN Programming
6.26 Programming Variables
Precondition for tool information: A tool call must be programmed
for the variables to become effective.
The assignment of variables #519..#521 varies depending on the type
of tool.
# variable Tool information
#514 Tool type:
 1: Turning tools
 2: Recessing tools
 3: Threading tools
 4: Drilling tools
 5: Taps
 6: Milling tools
#515 Tool orientation:
#519 For tool type 6: Number of teeth (K)
#520 For tool type:
 1, 2: Cutting radius (R)
 6: Milling diameter (I)
#521 For tool type 2: Cutting width (K)
#522 Tool orientation (reference: machining
direction of tool):
 0: On the contour
 1: To the right of the contour
 – 1: To the left of the contour
#523..#524 Set-up dimensions (Z, X)
#526..#527 Position of tool tip center I, K (see
figure below)