Operation Manual

432 8 Organization Mode of Operation
8.2 Parameters
Current parameters
Current parameters
"Setup (menu) [1]" menu item
Workpiece zero point [1]—Main spindle [1] Distance between "Machine zero point and workpiece zero point"
(usually determined with "Set axis values").
 Zero point coordinate X [mm]
 Zero point coordinate Z [mm]
Tool change point [2] Distance between "Machine zero point and tool change point"
(usually determined with "Set tool change point").
 Tool change point X coordinate [mm]
 Tool change point Z coordinate [mm]
Zero point shift, C axis [3]  Zero point shift, C axis [°]
Tool monitoring [4] Activate/deactivate tool life monitoring
 Tool life switch
 0: Off
 1: On
Additive compensation [5] 16 compensation value sets—you can also define this parameter
with "Set additive compensation."
 Compensation 901 in X
 Compensation 901 in Z
 Compensation 902 in X
 Compensation 902 in Z
 . . .
"Machine parameters [2]" menu item
Feed rates [1]—Manual control [1]  Rapid traverse contouring speed for manual control
 Feed rate contouring speed for manual control (usually set with
"Set T, S, F")
 Feed per revolution for manual control
Feed rates [1]—Automatic mode [2]  Feed rate for rapid traverse in X
 Feed-rate for rapid traverse in Z