Operation Manual

86 4 Cycle Programming
4.2 Workpiece Blank Cycles
Blank—bar/tube
Select the function for defining a workpiece blank.
Select "Blank—bar/tube."
The cycle describes the workpiece blank and the setup used. This
information is evaluated during the simulation.
Cycle parameters
 X outside diameter
 Z length—including transverse allowance and clamping range
 I inside diameter for workpiece blank "tube"
 K right edge (transverse allowance)
 B clamping range
 J type of clamping
 0: Not clamped
 1: Externally clamped
 2: Internally clamped