Operation Manual

216 Cycle programming
4.5 Recessing cycles
ICP recessing cycles, radial
Call the recessing cycles
Select recessing, radial ICP.
The cycle machines the number of recesses defined in number Qn with
the ICP recessing contour. The starting point defines the position of
the first recess.
Cycle parameters
X, Z Starting point
FK ICP finished part: Name of the contour to be machined
P Recessing width: infeeds <= P (no input: P = 0.8 * cutting
width of the tool)
ET Recessing depth by which one cut is fed.
I, K Oversize X, Z
EZ Dwell time for chip breaking (default: length of time for
two revolutions)
Qn Number of recess cycles (default: 1)
DX, DZ Distance to subsequent recess with respect to the
preceding recess
G14 Tool change point (see page 128)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
SX, SZ Cutting limits (see page 128)
G47 Safety clearance (see page 128)
MT M after T: M function that is executed after the tool call T