Operation Manual

232 Cycle programming
4.5 Recessing cycles
Recess turning, radial finishing
Call the recessing cycles
Select recess turning
Select recess turning, radial
Press the Finishing run soft key
The cycle finishes the contour area defined by the starting point and
contour end point (see also "Recess turning" on page 224).
With oversizes I, K for the workpiece blank, you define
the material to be machined during the finishing cycle. For
this purpose, enter the oversizes for recess turning,
finishing.
Cycle parameters
X, Z Starting point
X2, Z2 Contour end point
I, K Workpiece blank oversize X, Z
G14 Tool change point (see page 128)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
G47 Safety clearance (see page 128)
MT M after T: M function that is executed after the tool call T