Operation Manual
420 ICP programming
5.12 Face contours in smart.Turn
Circular pattern on face
You can find the reference dimension ZR with the "select reference
plane" function (see page 411).
ICP generates:
The FRONT section code with the reference dimension parameter.
In nested contours, ICP generates only one section code.
A G308 with the parameters contour name and milling depth (–
1*BT).
A G402 with the parameters of the pattern.
The G function and the parameters of the figure/hole.
A G309.
Reference data of face
ID Contour name
PT Milling depth
ZR Reference dimension
Parameters of pattern
XK, YK Center of pattern (Cartesian coordinates)
QP Number of points in pattern
DR Direction of rotation (default: 0)
DR=0, without EP: Figures are arranged on a full circle
DR=0, with EP: Figures are arranged on the longer
circular arc
DR=0, with EPi: The algebraic sign of EPi defines the
direction (EPi<0: clockwise)
DR=1, with EP: clockwise
DR=1, with EPi: clockwise (algebraic sign of EPi has
no effect)
DR=2, with EP: counterclockwise
DR=2, with EPi: counterclockwise (algebraic sign of
EPi has no effect)
DP Pattern diameter
AP Starting angle (default: 0°)
EP End angle (no entry: the pattern elements are equally
divided into 360°)
EPi Angle between two figures
H Element position
0: Normal – the figures are rotated about the circle
center (rotation)
1: Original position – the position of the figures relative
to the coordinate system remains unchanged
(translation)
Parameters of the selected figure/hole