Operation Manual

HEIDENHAIN MANUALplus 620 425
5.13 Lateral surface contours in smart.Turn
Polygon on lateral surface
You can find the reference diameter XR with the "select reference
plane" function (see page 411).
ICP generates:
 The SURFACE section code with the reference dimension
parameter. In nested contours, ICP generates only one section
code.
 A G308 with the parameters contour name and milling depth.
 A G317 with the parameters of the figure.
 A G309.
Reference data of lateral surface
ID Contour name
PT Milling depth
XR Reference diameter
Parameters of figure
Z Figure center
CYM Center of figure as linear dimension (reference: diameter XR)
CM Center of figure (angle)
A Position angle
Q Number of corners
K Length of edge
Ki Width across flats (inscribed circle diameter)
BR Rounding arc