Operation Manual

HEIDENHAIN MANUALplus 620 583
9.3 Technical information
User functions
Configuration  Basic version: X and Z axis, spindle
 Y axis (optional)
 Positionable spindle and driven tool (optional)
 C axis and driven tool (optional)
 B axis (optional)
 Digital current and speed control
 Rear-face machining with the opposing spindle (optional)
Manual operation  Manual slide movement through axis-direction keys or electronic
handwheel
 Graphic support for entering and running Teach-in cycles without
saving the machining steps in alternation with manual machine
operation
 Thread reworking (thread repair in a second workpiece setup)
(optional)
Teach-in mode  Sequential linking of Teach-in cycles, where each machining cycle is
run immediately after input, or is graphically simulated and
subsequently saved.
Program Run mode All are possible in single-block and full-sequence modes:
 DINplus programs
 smart.Turn programs (optional)
 Teach-in programs (optional)
Setup functions  Workpiece datum setting
 Definition of tool-change position
 Definition of protection zone
 Measurement of the tool by touch-off, touch probe, or optical gauge
 Workpiece measurement with a TS workpiece touch probe