Operation Manual

HEIDENHAIN MANUALplus 620 593
9.4 Compatibility in DIN programs
Syntax elements of the MANUALplus 620
Meaning of the symbols used in the table:
þ Compatible behavior; if necessary, the program converter
converts the functions so that they are compatible with the
MANUALplus 620
X Behavior changed; the program has to be tested in the
individual case
– Function is not available or is replaced by different
functionality
 Function is planned for future software versions or will only
be required for multi-channel systems
Section codes
Program head PROGRAMMKOPF [HEADER] þ
REVOLVER [TURRET] þ
SCHEIBENMAGAZIN [PLATE MAGZN.] þ
CHUCKING EQUIPMENT X
Contour definition KONTUR [CONTOUR] 
ROHTEIL [BLANK] þ
FERTIGTEIL [FINISHED] þ
HILFSKONTUR [AUXIL_CONTOUR] þ
C-axis contours STIRN [FACE_C] þ
RUECKSEITE [REAR_C] þ
MANTEL [LATERAL_C] þ
Workpiece machining BEARBEITUNG [MACHINING] þ
ZUORDNUNG [ASSIGNMENT] 
ENDE [END] þ
Subprograms UNTERPROGRAMM [SUBPROGRAM] þ
RETURN þ
Other CONST þ
Y-axis contours STIRN_Y [FACE_Y] þ
RUECKSEITE_Y [REAR_Y] þ
MANTEL_Y [LATERAL_Y] þ