User`s manual for cycle programming

ManualsBrandsHEIDENHAIN ManualsSoftwareTNC 640

Contents

HEIDENHAIN | TNC 640 | User’s manual for cycle programming | 9/2015

7 Fixed Cycles: Contour Pocket......................................................................................................195

7.1 SL Cycles..............................................................................................................................................196

Fundamentals........................................................................................................................................ 196

Overview............................................................................................................................................... 197

7.2 CONTOUR (Cycle 14, DIN/ISO: G37).................................................................................................198

Please note while programming:..........................................................................................................198

Cycle parameters.................................................................................................................................. 198

7.3 Superimposed contours..................................................................................................................... 199

Fundamentals........................................................................................................................................ 199

Subprograms: overlapping pockets.......................................................................................................199

Area of inclusion................................................................................................................................... 200

Area of exclusion.................................................................................................................................. 201

Area of intersection.............................................................................................................................. 202

7.4 CONTOUR DATA (Cycle 20, DIN/ISO: G120).....................................................................................203

Please note while programming:..........................................................................................................203

Cycle parameters.................................................................................................................................. 204

7.5 PILOT DRILLING (Cycle 21, DIN/ISO: G121)..................................................................................... 205

Cycle run............................................................................................................................................... 205

Please note while programming:..........................................................................................................206

Cycle parameters.................................................................................................................................. 206

7.6 ROUGHING (Cycle 22, DIN/ISO: G122)............................................................................................. 207

Cycle run............................................................................................................................................... 207

Please note while programming:..........................................................................................................208

Cycle parameters.................................................................................................................................. 209

7.7 FLOOR FINISHING (Cycle 23, DIN/ISO: G123)..................................................................................211

Cycle run............................................................................................................................................... 211

Please note while programming:..........................................................................................................212

Cycle parameters.................................................................................................................................. 212

7.8 SIDE FINISHING (Cycle 24, DIN/ISO: G124)..................................................................................... 213

Cycle run............................................................................................................................................... 213

Please note while programming:..........................................................................................................214

Cycle parameters.................................................................................................................................. 215