User`s manual for cycle programming

Touch probe table 13.3

HEIDENHAIN | TNC 640 | User’s manual for cycle programming | 9/2015

455

13.3 Touch probe table

General information

Various data is stored in the touch probe table that defines the

probe behavior during the probing process. If you run several touch

probes on your machine tool, you can save separate data for each

touch probe.

Editing touch probe tables

To edit the touch probe table, proceed as follows:

Select the Manual Operation mode

Select the touch probe functions: Press the

TOUCH PROBE soft key The TNC displays

additional soft keys

Select the touch probe table: Press the TCH

PROBE TABLE soft key

Set the EDIT soft key to ON

Using the arrow keys, select the desired setting.

Perform desired changes.

Exit the touch probe table: Press the END soft key