Product Manual

SAFETY and GENERAL INFORMATION
Save these instructions. For your safety read, understand, and follow the information provided with and on this lift.
The owner and operator of this equipment shall have an understanding of this lift and safe operating procedures before
attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills
and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of
this lift is authorized. If any doubt exists as to the safe and proper use of this lift, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked, or damaged parts (including labels) are noted. Any lift
that appears damaged in any way, operates abnormally or is missing parts, shall be removed from service immediately
and the manufacturer notified. If you suspect that the lift was subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), immediately discontinue use until the lift has been checked by a factory authorized service center
(contact distributor or manufacturer for list of Authorized Service Centers). It is recommended that an annual inspection
be done by qualified personnel. Replace worn or damaged parts with Hein-Werner Authorized Replacement Parts only.
Labels and owner’s manuals are available from manufacturer.
PRODUCT DESCRIPTION
Hein-Werner Air Operated End Lift is designed to lift, but not support rated capacity loads. Intended use: To engage
the metal bumper of a vehicle and raise for the purpose of service and/or repair of vehicle components. Immediately
after lifting, the load must be supported by a pair of appropriately rated jack stands.
Never use lift as a stand alone device. After lifting, immediately support the lifted load with
a pair of appropriately rated jack stands.
2
SPECIFICATIONS
!
Model Capacity Min.
Height
Max.
Height
Power
Travel
Saddle
Spread
Min. Air Pressure
for Rated Load
Weight
HW93690 10 Ton 12 1/2" 50 1/2" 28" 25" to 53" 200 psi 670 lb.
Figure 1 - Model HW93690 Components
Air Cylinder
Handle Grip
Base Section
Lifting Beam
Safety Bar Level
(rear, not shown)
Air input
(1/4" NPT)
Saddle
Rear wheel
Caster
Lift Control
Level
Valve Stem
Air Input
Locking Bolt