Product Manual

3
! WARNING
• Study, understand, and follow all printed materials
provided with/on this product before use.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• This is a lifting device only!
• Immediately after lifting, support the load with
a pair of appropriately rated jack stands.
• Center load on saddle.
• Do not use adapters or accessories that are not
provided initially.
• Never lift vehicle which cannot roll freely forward
and backward during lift.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer.
• Do not move or dolly loads with this device.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
• Leer, comprender, y seguir las instrucciónes antes
de utilizar el aparato.
• El manual de instrucciónes y la información de
seguridad deben estar comunicado en lengua del
operador antes del uso.
• No seguir estas indicaciónes puede causar daños
personales o materiales.
! ADVERTENCIA
To avoid crushing and related injuries:
• Never work on, under or around a load supported
only by the end lift.
• Always use adequately rated jack stands.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
! WARNING
X
PREPARATION
Before Use
1. Verify that the product and application are compatible, if in doubt call Hein-Werner technical service.
2. Before use, read the operator’s manual completely and familiarize yourself thoroughly with the product, its
components and recognize the potential hazards associated with its use.
3. Ensure that lift rolls freely, the air cylinder operates smoothly, raises and lowers the unloaded saddle throughout
the lifting range before putting into service.
4. Ensure the lift is loaded on center with the saddles placed equal distance from the center.
5. Replace worn or damaged parts and assemblies with Hein-Werner Replacement Parts only. Lubricate as
instructed in Maintenance Section.
Prepare air system
Connect 1/4" NPT quick coupler of your choice to the air input (Fig. 1).
Note: Air source must supply 200 psi maximum to each lift operated.