Product Manual
OPERATION
Only attachments and/or adapters supplied by the manufacturer shall be used. Lift only on areas of the
vehicle as specified by the vehicle manufacturer.
NEVER use lift as a stand alone device! ALWAYS transfer the lifted load IMMEDIATELY to a pair of
appropriately rated jack stands. Use one pair of jack stands per vehicle. Rated capacity is per pair only!
Do not exceed rated capacity.
Lifting
1. Ensure that the vehicle is on a flat, hard and level surface and is free to roll forward and backward during the lift.
2. Connect 1/4" NPT air nipple and air hose to air inlet port.
3. To adjust the length of the lifting beams, pull both beam extensions out evenly to suitable length.
NEVER extend beam extensions beyond locked position. Retaining bar of the beam extensions must be
secured together with the locking bolt.
4. Adjust the saddle height by pulling saddle tube up, then insert the support pin through the hole on saddle tube.
5. For low pickup height, uncsrew the locking bolt and nut, then rotate the beam extensions 180 degrees. Refer to
Figure 2.
4
!
!
6. Make sure both saddles are positioned directly under the vehicle manufacturer's recommended lift points.
7. To raise lift, slowly push the lift control lever toward the right until saddles contact with the lift point.
!STOP! RELEASE THE LIFT CONTROL LEVEL! Confirm that the saddles are positioned correctly, then continue
to push the lever until load reaches desired height. Simply release the lever to stop.
8. Transfer the load immediately to appropriately rated jack stands.
Lowering
Be sure all tools and personnel are clear before lowering load. Maintain control of the rate of speed at
which the load lowers at all times!
1. Raise load high enough to clear the jack stands, then carefully remove jack stands (always used in pairs).
2. Slowly lower the load by disengaging safety bar* and push lift control lever toward the left.
* To disengage safety bar: Push safety bar lever towards front end of the lift.
!
Figure 2.
Support Pin
Saddle Tube
Locking Bolt
Lifting Beam
Beam Extension
180
O
Saddle
Retaining Bar
!