Installation Guide

2
2.Foot massager with mounting balls if your model ordered has this function. Flexible water
hose for the foot massager and through-wall elbow, washers and a ring nut.
3.10 cup washers and decorative chrome covers
4.1”, ½”, and 1/4" long screws
5.Glass shelf and its mounting bolts, washers, and nuts
6.Shower head sliding bar and its mounting bolts, washers and nuts.
7.Flexible water hose for hand-held shower and through-wall elbow, washers and a ring nut.
8.Hand-held shower head
9.8 door rollers
10.2 door handles
1. Pre-installation
Check the area you want to install your unit for the following:
a.Water hook-ups
b.Floor drain
c.Wall studs. Measure the area to ensure that once the unit is installed, the screw holes
located at the top of the enclosure walls will align with a wall stud.
d.120V outlet, if your unit has a built-in radio
2. Base Preparation
a.Remove the shower base or bath tub
from its packaging.
b.Remove all protective covering films
from the base.
c.Adjust the feet of the base so that the
base is level when lying flat on the
ground.
d.Remove the plastic tubing and unscrew
the top from the white plastic drain.
e.Place the top portion into the drain hole
in your base.
f.Apply silicone sealant to the bottom
portion of the white plastic drain (about
¼” from the edge of the rim) and place it
over the drain hole from the underside of
the base.
g.Screw the top of the plastic drain into the
bottom until tight. Do not over tighten
as this may crack the plastic.
h.Reattach the plastic piping to the plastic
drain.
i.Extend the piping and feed it into the
floor drain. You may use 1-1/4” to
2” coupling to secure the drain pipe to
your floor drain.