User manual

H. Vollmer GmbH

Installation instructions Art. No: 27010-27017 Page 1 of 3 Status 01.12.2015

GB Installation and operating instructions

LED Panels

Art. No. 27010-27017

These operating instructions apply exclusively to these products.

They contain important instructions for commissioning and handling the LED-Panels.

Please therefore follow these operating instructions, even if you pass this product on to third

parties.

It is important for this reason that you keep these instructions in a safe place for future reference.

1. Introduction

Dear Customer,

Many thanks for deciding to buy our product.

You have obtained a product from the Vollmer Company and this product has been manufactured in

compliance with the state of the art technology.

The LED-Panel meets the requirements of the European and national directives currently in force.

As a user, you must follow these operating instructions to maintain the condition of the product and to

operate it safely!

2. Safety notes

 Damage caused by non-compliance with these operating instructions, invalidates all warranty claims!

 We undertake no liability for consequent damages!

 Commissioning the LED-Panel is strictly forbidden if there is damage.

 Never let children play unattended near the LED-Panel or other electrical devices.

 Do not expose the LED-Panel to extreme heat or open flames.

 The entire product must not be converted or modified. Changes if made to the LED-Panel shall

invalidate the warranty.

 The rating plate must not be removed.

 Do not stare directly at the LED light beam.

 The light source of this luminaire is not replaceable.

 When the light source reaches its end of life the whole luminaire shall be replaced.

3. Intended Use

The LED panel is designed for indoor use in dry and protected conditions.

This product is only intended for lighting purposes and may:

 only be operated with a voltage of 12V

 only be operated when it is firmly attached to a stable, level and tilt-free base.

 only be operated on normal or non-inflammable surfaces.

 not be exposed to strong mechanical loads or large amounts of dirt.

Heitronic

H. Vollmer GmbH

Allmendring 29

D-75203 Königsbach Stein

PAGE 1
H. Vollmer GmbH GB Installation and operating instructions LED Panels Art. No. 27010-27017 These operating instructions apply exclusively to these products. They contain important instructions for commissioning and handling the LED-Panels. Please therefore follow these operating instructions, even if you pass this product on to third parties. It is important for this reason that you keep these instructions in a safe place for future reference. 1.
PAGE 2
H. Vollmer GmbH 4. Before installation/commissioning     The LED-Panel may only be operated after removing the packaging. Take the LED-Panel carefully out of the packaging. Before commissioning the LED-Panel make sure that it has not been damaged in transit. The LEDPanel must not be operated if the electrical components have been damaged. Repairs may only be undertaken by a specialist electrician. Keep the packaging material well away from children and household pets. Danger of suffocation! 5.
PAGE 3
H. Vollmer GmbH 7.