User manual

1 of 3 | Dated 26.02.2016

GB Installation and Operating Instructions

LED panel

Art. No. 27794,27795,27796

These operating instructions refer exclusively to the above products.

They contain important information for the start-up and handling of the light.

Therefore, follow these operating instructions, even if you pass this product onto a third party.

It is important, therefore, that these instructions are archived carefully for referring to information at a

later stage.

1. Introduction

Dear customer, thank you for deciding to purchase our product.

You have acquired a product from Vollmer, which has been built according to the current state of technology.

The light fulfils the requirements of effective European and national guidelines

To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the

instructions of this operation manual!

2. Safety Instructions

 The guarantee becomes invalid if damage occurs due to the failure of following these operating

instructions!

 We do not accept liability for any consequential damage!

 Commissioning is strictly prohibited if there are any damages to the light.

 Do not allow children to play unsupervised near the light.

 Do not allow the light to come into contact with extreme heat or naked flames.

 The product in its entirety must not be altered or modified. Alterations to the light invalidate the

guarantee.

 The type plate must not be removed.

3. Proper Use

The light is designed for use in outdoor/indoor areas.

This product is only intended for lighting purposes and may:

 only be operated with a voltage of 230V ~50Hz

 only be connected according to protection class II (two)

 only be operated when mounted to a sturdy, level and non-tilting surface

 only be operated on normal or non-flammable surfaces

 not be subjected to strong mechanical loads or heavy soiling.

4. Before Installation/Commissioning

 The light may only be operated once removed from the packaging.

 Remove the light from the packaging carefully.

 Make sure that the light has not been damaged during transport before taking it into operation. The light

may not be operated if there are any damages to electrical parts. Repairs may only be carried out by a

qualified electrician.

 Keep packaging materials away from children and pets. Asphyxiation hazard!

PAGE 1
GB Installation and Operating Instructions LED panel Art. No. 27794,27795,27796 These operating instructions refer exclusively to the above products. They contain important information for the start-up and handling of the light. Therefore, follow these operating instructions, even if you pass this product onto a third party. It is important, therefore, that these instructions are archived carefully for referring to information at a later stage. 1.
PAGE 2
5. Installation/Commissioning         This product can only be installed by a qualified electrician. The connection lines in the building must be disconnected before installation and secured against being switched back on. For this, trip the corresponding fuse switch in the building installation. Make sure that the surface is suitable for permanently and reliably taking the weight of the light. Using a saw, cut out the installation dimensions at the desired position.
PAGE 3
10. Waste Disposal  Old electronic devices must be taken to public waste disposal sites and must not be put into general household waste. 3 of 3 | 26.02.