Quick Start Owner's manual

ManualsBrandsHeli-Max ManualsAir equipmentHMXE0805

1

QUICK START CHECKLIST

WARNING!! The instruction manual must be read completely before

operating the Novus AH-1J SeaCobra. It contains speciﬁ c warnings about

safety and use of the LiPo ﬂ ight battery supplied with the Novus AH-1J SeaCobra. All

of these warnings and safety steps must be read and understood before proceeding to

the next step.

❑

1. Plug the wall transformer into an AC

outlet. The power indicator light on the wall

transformer will be green and the charge

indicator light will be solid red.

❑

2. Plug the battery into the charger. When

the battery is completely charged, the charge

indicator light will turn green (solid or ﬂ ashing).

Disconnect the battery from the charger.

❑

3. Install (8) AA Alkaline batteries into

the transmitter.

❑

4. Install the Flight Battery.

™

QUICK START CHECKLIST

WARNING!! The instruction manual must be read completely before

operating the Novus AH-1J SeaCobra. It contains speciﬁ c warnings about

safety and use of the LiPo ﬂ ight battery supplied with the Novus AH-1J SeaCobra. All

of these warnings and safety steps must be read and understood before proceeding to

the next step.

❑

1. Plug the wall transformer into an AC

outlet. The power indicator light on the wall

transformer will be green and the charge

indicator light will be solid red.

❑

2. Plug the battery into the charger. When

the battery is completely charged, the charge

indicator light will turn green (solid or ﬂ ashing).

Disconnect the battery from the charger.

❑

3. Install (8) AA Alkaline batteries into

the transmitter.

❑

4. Install the Flight Battery.

™

Summary of content (2 pages)

PAGE 1
™ ™ QUICK START CHECKLIST QUICK START CHECKLIST WARNING!! The instruction manual must be read completely before operating the Novus AH-1J SeaCobra. It contains specific warnings about safety and use of the LiPo flight battery supplied with the Novus AH-1J SeaCobra. All of these warnings and safety steps must be read and understood before proceeding to the next step. ❑ 1. Plug the wall transformer into an AC outlet.
PAGE 2
❑ 5. Connect the flight battery to the ESC. ❑ 6. Position throttle stick in lowest position. ❑ 7.Turn the transmitter on. ❑ 5. Connect the flight battery to the ESC. ❑ 6. Position throttle stick in lowest position. ❑ 7.Turn the transmitter on. ❑ 8. Wait while the transmitter binds to the receiver (the logo on the ❑ 8. Wait while the transmitter binds to the receiver (the logo on the ❑ 9. Leave the helicopter still for 5 seconds so the gyro can perform ❑ 9.