User Manual

TRANSMITTER SETUP

1. Install 4 AA batteries in the transmitter

by removing the battery cover from the

back of the transmitter. Double-check

the polarity of each battery before

replacing the battery cover.

2. Turn the transmitter on and lay it

down. Make sure that the blue light

behind the Heli-Max panel is lit. The

LCD screen should be on, with a

throttle position indicator and other

information.

3. Make sure the electronic trim

indicators on the display are centered.

NOTE: The transmitter must remain

still when first turned on to allow it to

calibrate.

FLYING YOUR 230Si QUADCOPTER

Electric motors are very dangerous. Do not work on the model

while the flight battery is plugged in as interference may cause

the main rotor blades to spin, possibly causing injury.

Turn on the TX465 transmitter and lay

it down near the quadcopter on a level

surface. When the display shows 000,

connect the battery but do not move

the quadcopter. When the Status LED

is steady, the 230Si can be picked up.