User Manual

channels “turned on” and separate switches mapped to those channels

before linking the transmitter to the V-Cam. Make sure all these channels

are adjusted to maximum endpoints (EPA)!

Programming Order Will Be Flip, Video

and Lastly Still Picture

❏

1. Move the transmitter’s throttle stick to the lowest position, all switches

back, and dials to full CCW.

❏ 2. Power the quad; the LED will glow solid.

❏ 3. Press and hold the link button for 3 seconds, then release. The LED will

remain solid.

❏ 4. Power on the transmitter and move the aileron stick full right. Hold

until the LED starts flashing.

❏ 5. Two seconds after flashing begins return the aileron stick to center (THE

QUAD IS NOW IN SELF DEFINING MODE). The LED will be flickering.

❏

6. Pick a CHANNEL for flipping. Flip the switch back and forth 3 or

more times to complete. (Note: we like to program the trainer switch

for this function).

❏ 7. Pick an unused CHANNEL for Video. Flip the switch back and forth

(or rotate the dial fully lock to lock) 3 or more times to complete.

❏ 8. (IF YOU ARE USING A 7 OR MORE CHANNEL TRANSMITTER) Pick

an unused CHANNEL for Picture. Flip the switch back and forth (or

rotate the dial fully lock to lock) 3 or more times to complete.

❏ 9. Finally, move the rudder stick full left and hold for 5 seconds, then

return the stick to center. You have exited setup mode. The LED will

normally flash once when the programming has been accepted. The

quad is now bound to the transmitter and you have programmed the

(up to) three operation features.

To see a video of this

process go to the Heli-Max

1SQ V-cam webpage.

helimax-rc.com